Publicidad
Step 10
Separate the WIDE EXTENSION SLIDES (Z) from the WIDE EXTENSION RAILS (Y) as shown in the upper diagram below.
å
Be prepared, the parts are greasy.
Fasten the WIDE EXTENSION RAILS (Y) to the ENDS (A and B) and UPRIGHTS (D and E). Use eight GOLD 5/16" FLAT
å
HEAD SCREWS (3S) through holes #1 and #3.
NOTE: For each WIDE EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the WIDE EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the ENDS and UPRIGHTS.
Turn a SCREW into this hole.
NOTE: The WIDE EXTENSION SLIDES will be used later for the LARGE DRAWERS.
å
Push the black lever in and pull the SLIDE from the RAIL.
3S
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
Edge with
TWIST-LOCK®
FASTENERS
P
Open end
Edge with
TWIST-LOCK®
FASTENERS
P
Open end
Page 14
Separate the WIDE EXTENSION SET (Y and Z)
from the NARROW EXTENSION SET (AA and BB).
Z
B
4
3
2
1
Y
D
4
3
2
1
Y
Y
H
A
3
4
E
419954
Open end
1
2
Y
Edge with
TWIST-LOCK®
FASTENERS
H
1
2
3
Y
4
www.sauder.com/services
Open end
Publicidad
