Publicidad
Step 12
Turn the UPRIGHTS (D and E) over.
å
Fasten the EXTENSION BLOCKS (T) to the UPRIGHTS (D and E). Use four BLACK 1-1/4" FLAT HEAD SCREWS (7S).
å
Fasten the remaining two NARROW EXTENSION RAILS (AA) to the UPRIGHTS (D and E). Use four GOLD 5/16" FLAT
å
HEAD SCREWS (3S) through holes #1 and #3.
NOTE: For each NARROW EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the
å
inner cartridge of the NARROW EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the ENDS and
UPRIGHTS. Turn a SCREW into this hole.
3S
GOLD 5/16" FLAT HEAD SCREW
(4 used for the RAILS)
4
3
Open end
2
1
AA
T
H
Page 16
Surface with
more holes
Unfi nished
strip
The large hole
must be here.
E
1
2
AA
3
4
T
D
419954
Open end
7S
BLACK 1-1/4" FLAT HEAD SCREW
(4 used for the EXTENSION BLOCKS)
P
www.sauder.com/services
Publicidad
