Publicidad
Step 11
Separate the NARROW EXTENSION SLIDES (BB) from the NARROW EXTENSION RAILS (AA) as shown in the upper
å
diagram below. Be prepared, the parts are greasy.
Fasten eight NARROW EXTENSION RAILS (AA) to the ENDS (A and B) and UPRIGHTS (D and E). Use sixteen GOLD 5/16"
å
FLAT HEAD SCREWS (3S) through holes #1 and #3.
NOTE: For each NARROW EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the
å
inner cartridge of the NARROW EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the ENDS and
UPRIGHTS. Turn a SCREW into this hole.
NOTE: The NARROW EXTENSION SLIDES will be used later for the SMALL DRAWERS and PENCIL DRAWER.
å
GOLD 5/16" FLAT HEAD SCREW
(16 used in this step)
3
2
1
AA
2
1
AA
Open end
2
1
AA
Open end
www.sauder.com/services
BB
Push the black lever in and pull the SLIDE from the RAIL.
3S
4
4
3
B
4
3
4
3
2
1
AA
D
AA
1
2
1
3
AA
4
2
3
AA
4
A
2
3
4
AA
3
4
419954
Open end
Open end
1
1
2
AA
E
Page 15
Publicidad
