Cleaning, Maintenance And Ordering Of Spare Parts; Disposal And Recycling - Neptun NRP-E 40 Manual De Instrucciones

8. Cleaning, maintenance and
ordering of spare parts
Danger!
•
Unplug the power plug prior to any mainte-
nance work.
•
For mobile applications, the equipment
should be cleaned with clear water after every
usage.
•
For stationary installation, it is recommended
that you check the floating switch for proper
operation every three months.
•
Use a water jet to remove any lint or fibrous
particles that may have become trapped in
the housing.
•
Remove sludge from the shaft bottom and
clean the shaft walls every 3 months.
•
Use clear water to remove deposits from the
floating switch.
8.1 Cleaning the fi lter (Figs. 6 – 7)
In order to protect the equipment and the impeller
from severe soiling, an additional fi lter has been
installed in the bottom intake cage. Proceed as
follows when cleaning the fi lter:
1. Gently press the lateral tab (A) in the direction
of the arrow until the intake cage (3) can be
disconnected from the pump.
2. Remove the fi lter (B) and wash it out under
running water.
3. Finally reinsert the fi lter in the intake cage and
refi t the intake cage on the equipment.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
Anl_NRP-E_40_SPK7.indb 17 Anl_NRP-E_40_SPK7.indb 17
GB

9. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
10. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
- 17 -
01.02.2021 13:12:11 01.02.2021 13:12:11