Spare Parts; Technical Data - Hansgrohe Picta 31011 Instrucción De Montaje

Assembly
1 Flush through the supply pipes.
2 Place the mixer including the sealing washer in
position on the basin / bidet.
3 Slip the fixation piece including the washer over t
he threaded pins and tighten the nuts.
4 Connect the supply pipes to the angle valves;
cold right - hot left.
5 Connect the pull rod to the pop-up waste.
Large differences in pressure between the hot and cold
water supply should be balanced.
Operation
The mixer is actuated by lifting the lever head.
Swivel to the left = hot water,
swivel to the right = cold water.

Technical Data

Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temperature: 65° C
Rate of flow:
Hansgrohe single lever mixers can be used together with
hydraulically and thermically controlled continuous flow
heaters if the flow pressure is at least 1.5 bars.
If the continuous flow heater makes any problems or there
comes not enough water, the flow limiter (8a) located
behind the mousseur must be removed.
To adjust the hot water limiter on single lever mixers, please
see page 12.
No adjustment is necessary when using a continuous flow
water heater.
6
English

Spare parts

1
1.1screw cover
2
3
4
5
6
7
8
9
10
11
max. 10 bars
1 - 5 bars
16 bars
max. 80° C
7,2 l/min. 3 bar
lever head
flange
nut
service set
seals
mixer ball
mixing unit cpl.
mousseur cpl.
pull rod
fixation cpl.
connection hose
94186
94130
94106
13952
13962
13964
14095
13085
92620
94138
94076
6