Panasonic TY-WK5P1RW Manual Del Usuario página 8

Fitting procedure
5. Installing the insulation spacers onto the
plasma TV
 Place the plasma TV face down on a clean blanket or other
piece of fabric free from dirt and foreign matter, and proceed as
instructed below.
Take care to prevent scratches or damage if the plasma TV has
protruding parts.
 Use a Phillips head screwdriver to remove the caps (4) from the
plasma TV.
Note
• Keep the caps which have been removed in a safe place.
(They will be required when a separate installation stand is used.)
 As shown in the figure on the right, install the accessory M8×32
Allen head countersunk screws , dished toothed washers ,
insulation spacers  and spacers  (x4 for each part) using
included allen wrench  at the locations where the caps were
previously installed.
(Tightening torque: 3 to 4 N•m)
6. Mounting the plasma TV onto the wall-
hanging bracket and connecting it to the
other components
 Remove the left and right red-marked screws  (one at the left
and one at the right) used to anchor and release the plasma TV.
 Fit the insulation spacers at the top of the plasma TV onto the
cutouts at the top of the wall-hanging bracket, and lower the
plasma TV.
 Pull the plasma TV toward you as shown in the figure on the
right, and connect it to the other components.
 After completing the connections, lift the plasma TV slightly,
and insert the insulation spacers at the bottom into the holes at
the lower part of the wall-hanging bracket.
 Now lower the plasma TV.
CAUTION
• If the plasma TV is lifted too much, its top part will become disengaged
from the wall-hanging bracket.
8
All manuals and user guides at all-guides.com
* Appearance of the plasma TV differs according
to the model. The figure below is an example
of an applicable model.
Phillips head screwdriver
Cap
Blanket
Blanket
Insulation spacer at top
Red-marked screw  used
to anchor and release the
plasma TV
Hole at bottom



Cutout at top
Insulation spacer at bottom





