Programming; To Add Or Reprogram An Additional Hand-Held Remote Control; To Erase All Codes From Motor Unit Memory; 3-Button Remotes - Merik SECURITY + 511MM FS2 Manual Del Propietário

PROGRAMMING

NOTICE: If this Security ✚
the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚

To Add or Reprogram an Additional Hand-held Remote Control

1. Remove the cover from the Lighted Door Control.
2. Press and hold the button on the hand-held remote* that you wish to operate your garage door.
3. While holding the remote button, press and hold the "A" button on the Lighted Door Control.
4. Continue holding both buttons while you press the "B" button on the Lighted Door Control (all three
buttons are held).
5. Release buttons when the motor unit lights blink. It has learned the code. If light bulbs are not installed,
two clicks will be heard.
To Erase All Codes From Motor Unit
Memory
To deactivate any unwanted remote, first
erase all codes:
Press and hold the "learn" button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous codes are now
erased. Reprogram each remote or keyless entry you wish
to use.
®
garage door opener is operated with a non-rolling code transmitter, the technical measure in
USING THE LIGHTED DOOR CONTROL

*3-Button Remotes

If provided with your garage door opener, the large button is
factory programmed to
operate it. Additional buttons
®
on any Security✚ 3-Button
remote or mini-remote can
be programmed to operate
®
other Security✚ garage
door openers.
36
®
remote controls.
"A"
Button
"B"
Button
"A"
Button
"B"
Button