To Add, Reprogram Or Change A Keyless Entry Pin - Merik SECURITY + 511MM FS2 Manual Del Propietário

To Add, Reprogram or Change a Keyless Entry PIN

NOTE: Your new Keyless Entry must be programmed to operate your garage door opener.
NOTE: These methods requires two people if the Keyless Entry is already mounted outside the garage.
1. Remove the cover from the Lighted Door Control.
2. Enter a four digit personal identification number (PIN) of your choice on the keypad. Then press and
hold ENTER.
3. While holding the ENTER button, press and hold the "A" button on the Lighted Door Control.
4. Continue holding the ENTER and "A" buttons while you press the "B" button on the Lighted Door
Control (all three buttons are held).
5. Release buttons when the motor unit lights blink. It has learned the code. If light bulbs are not
installed, two clicks will be heard.
To change an existing, known PIN
If the existing PIN is known, it may be changed by one
person without using a ladder.
1. Press the four buttons for the present PIN, then press and
hold the # button.
The opener light will blink twice. Release the # button.
2. Press the new 4-digit PIN you have chosen, then
press Enter.
The motor unit lights will blink once when the PIN has been
learned.
Test by pressing the new PIN, then press Enter. The door
should move.
To set a temporary PIN
You may authorize access by visitors or service people with a
temporary 4-digit PIN. After a programmed number of hours
or number of accesses, this temporary PIN expires and will
no longer open the door. It can be used to close the door
even after it has expired. To set a temporary PIN:
1. Press the four buttons for your personal entry PIN (not the
last temporary PIN), then press and hold the ✽ button.
The opener light will blink three times. Release the button.
USING THE LIGHTED DOOR CONTROL
2. Press the temporary 4-digit PIN you have chosen, then
3. To set the number of hours this temporary PIN will work,
3. To set the number of times this temporary PIN will work,
The opener light will blink once when the temporary PIN has
been learned.
Test by pressing the four buttons for the temporary PIN, then
press Enter. The door should move. If the temporary PIN was
set to a certain number of openings, remember that the test
has used up one opening. To clear the temporary password,
repeat steps 1-3, setting the number of hours or times to 0 in
step 3.
37
press Enter.
The opener light will blink four times.
press the number of hours (up to 255), then press ✽.
press the number of times (up to 255), then press #.
"A"
Button
"B"
Button
OR