Remington PG6060 Manual Del Usuario página 4

ENGLISH
C HOW TO USE
, Attaching and removing guide combs
• With the trimmer blade facing away from you, slide the guide comb over the back of
the trimmer blade and click into position.
• With the trimmer blade facing away from you, carefully push the guide comb away
from the wide head trimmer.
, Before you begin
Comb facial hair with a fine comb before you start trimming. Hairs should be dry and without
any waxes or lotions before using the groomer.
, To thin and taper beards or moustaches
• Attach the wide trimmer blade.
• Place the hair length attachment on the trimmer blade, select the desired length and
switch on.
• Start trimming under the chin, following the jawbone line. Work toward the ear and
upper beard line using an upward motion.
, To Trim edge of beards or moustaches
• Attach the detail trimmer blade.
• Hold groomer with cutting blade facing you.
• Start with edge of beard/moustache line, and with the cutting blades resting lightly
against your skin, use slow movements to create a beard/moustache line.
, To trim sideburns
• Hold groomer with cutting blade facing you.
• Use a small comb to lift the hairs. Hold the comb at the desired beard or moustache
length.
• Move the groomer along the comb to cut the hairs. Use light pressure and
well-controlled movements to trim hair.
, Trimming the nape of your neck
• Attach the wide trimmer blade.
• Use your fingers to lift the hair at the base of your head up off the neck. Your index
finger should be covering the roots of the hairs you are lifting to prevent accidental
removal by groomer.
• Using your other hand, hold the groomer to the base of your neck with the cutting unit
facing up, and move the groomer up the length of the neck until the unit touches your
finger covering the hair roots at the base of your head. Move the unit slowly when
performing this operation and to keep the hair roots at the base of your head out of the
way of the groomer.
4