Intended Use; Safety Informations - BGS technic 62630-1 Manual Del Usuario

CAUTION
Read the operating instructions and the included safety informations carefully before using the
product. Use the product correctly, with caution and only for the intended purpose. Failure to observe
the safety information can lead to damage, injury and voiding of the warranty. Please keep these
instructions in a safe and dry place for future reference. Include the operating instructions if you pass
the product on to third parties.

INTENDED USE

This Injector Gasket Puller has been specially developed to help with the extraction of the copper
gaskets used to seal diesel injectors in place where the enter the cylinder head. The gaskets are
located at the bottom of the cylinder head. Often the gasket is so deep into the cylinder which makes
extraction using a pick near impossible. The injector seals are prone to failure and with the addition of
carbon build up around them makes extraction more difficult. The tool has been tapered and threaded
so that it screws into the centre of the gasket this will provide grip now the slide hammer can be used
to break the gasket between the washer and the cylinder head allowing extraction. It is not advised
that technicians use unsuitable tools or equipments to remove the gasket, there is a risk to damage
the injectors seat.

SAFETY INFORMATIONS

•
Always read the instructions carefully before using the tool.
•
Follow the manufacturer's specifications. This manual is supposed to inform you about the tool
itself and does not replace specific servicing handbooks.
•
Keep children and unauthorized persons away from the working area.
•
Do not let children play with this tool or its packaging.
•
Ensure the working area has adequate lighting
•
Keep working area clean and tidy, dry and free from unrelated materials
•
Do not allow untrained persons to use this tool kit
•
Always wear eye protection and gloves when working with this tool.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Injector Gasket Puller, 350 mm
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 62630-1
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed