vitapur VWD1066BLS Manual De Uso Y Cuidado página 8

6. When the handle is in the vertical (locked) position, it is possible to lift the water
bottle. However, when installing the 5 gallon water bottle inside the storage
compartment, the handle must be in the horizontal position.
Important:
Do not break or remove the seal from around the neck of the water
bottle otherwise you will not be able to lift or carry the water bottle with the carry
handle.
7. To install the water bottle inside the bottle storage compartment, simply position the
bottle in front of storage compartment ramp and (push) slide inside using the side of
your leg until the bottle comes to a stop.
8. Close the lower compartment door and the water pump will start delivering water into
the dispenser automatically. When the internal reservoirs are full, the water pump will
stop automatically.
READY-TO-DISPENSE INDICATOR LIGHTS
FLASHING
STEADY ON
RED
STEADY ON
BLUE
FLASHING
YELLOW
Operation
1. DISPENSING ROOM AND COLD WATER
² Place a glass under the dispensing spigot (J) in the
center of the water outlet panel.
² For cold water, press/hold dispensing button (G) until
the desired amount of water is dispensed and release
the button.
² For room temperature water, press/hold dispensing
button (F) until the desired amount of water is
dispensed and release.
All manuals and user guides at all-guides.com
Heater (hot water tank) is operational
The hot water has reached optimum
temperature and is ready for dispensing
OFF Hot water tank heating system is off, however
water within the tank may still be very hot,
always exercise caution when dispensing and/
or draining water from the hot water tank
The cold water has reached optimum
temperature and is ready for dispensing
OFF The cooling cycle is in progress. It is possible
to dispense water during the cooling cycle,
however, optimum cooling temperature may
not yet be achieved
Low water level inside internal reservoir. The
water bottle is empty
OFF The status of all water levels are normal
F G
J