Adjusting The Cold Water Temperature; Dispensing Hot Water - vitapur VWD1066BLS Manual De Uso Y Cuidado

2. ADJUSTING THE COLD WATER TEMPERATURE

² By turning the thermostat (M) at the back of the unit,
the temperature can be adjusted. Turn the dial clock
wise between the Min. (cool) and Max. (colder) levels
until the desired temperature is reached.
Note:
If the water dispenser is not
dispensing water, there could be a possible
ice build up due to the thermostat being
set too cold. If this happens, unplug the
dispenser overnight and then reset. Set
thermostat to Min, slowly increasing based
on your use and need for cold water.

3. DISPENSING HOT WATER

Warning:
The hot water is heated to approximately 194˚ F / 90˚C. Temperatures
above 125˚ F / 52˚ C can cause severe burns from scalding. DO NOT ALLOW
CHILDREN TO USE THE HOT WATER DISPENSING BUTTON WITHOUT
PROPER AND DIRECT SUPERVISION
Important:
feature (low water level sensor) that controls activation/operation of the Kettle
Feature hot water tank heating system. If no water is present and/or low water
levels are detected inside the internal water reservoir, activation/operation of
the Kettle Feature hot water heating system is not possible. Likewise, if the hot
water heating system is operational and water is being drawn simultaneously
causing internal water levels to drop below the established minimal level set
point, hot water tank operation is automatically suspended. To reactivate the
hot water heating system, you must replenish your water supply.
the cold water system is not affected by this safety feature.
² Press the red Kettle Feature button (B). The
red light will begin flashing.
² In less than 3 minutes, the red light will stay
on indicating that the hot water is ready for
dispensing.
² Place a glass under the spigot (J).
² Press the child resistant safety button (D) and
hold.
² Press the hot water button (E) and until the
desired amount of water is dispensed. To
prevent hot water from being dispensed
accidentally and possibly harming a child, the
hot water dispensing tap can only be operated
when the child resistant safety feature (D) is
activated.
² Upon releasing the hot water button (E), the
child safety lock automatically returns to the
locked position.
² To stop/cancel the Kettle Feature during a cycle,
simply press the Kettle Feature button (B) a
second time and the red LED light will stop flashing.
All manuals and user guides at all-guides.com
Your vitapur® water dispenser is designed with a special safety
M
TEMP
M
Min.
Max.
D
E
J
Operation of
B