Quick THG 512 Manual Del Usuario página 11

WARNING
WARNING:
Never place any object or part of the body in the area where the strap-roller runs.
Make sure the electric motor is off when capstan is used manually; people with a remote control (remote control or con-
trol system via radio) might accidentally operate the capstan.
CAPSTAN USE
Start the boat engine; use the control at hand to turn on the capstan. If the capstan stops and the magnetic-hydraulic (or mag-
netic thermal) cut-out has tripped, re-arm the cut-out and wait a few minutes before restarting.
Now power the capstan and you can wind the strap-roller around the sprocket. Be careful that it is properly wound.
MAINTENANCE
13
12
2
11
1
14
15
23
19
20
18
21
N. DESCRIPTION
1 Gearbox 500W H series
2 External circlip
3 Oil seal
4 Internal circlip
5 Bearing
6 THG base plate
7 Screw
8 Screw
9 Grower
10 Washer
11 Shaft THG series
THG 500 - REV000A
WARNING - USAGE - MAINTENANCE
8
9
10
25
24
2
24 25
16
23
22
12 Key
13 Key
14 Pin
15 THG capstan base
16 Pin
17 Stud
18 THG sprocket base; Ø 190
19 THG sprocket body
20 Pin
21 THG sprocket base; Ø 190
22 Screw
23 Screw
31
29
28
27
26
3
4
6
5
7
7
17
33
32
30
WARNING:
make sure the electrical
power to the motor is switched off
when working manually on the cap-
stan. Carefully remove the strap-roller from
the drum.
Quick capstans are manufactured with
®
materials resistant to marine environments.
In any case, any salt deposits on the outside
must be removed periodically to avoid cor-
rosion and damage to the equipment. The
parts where salt may have built up should
be washed thoroughly with fresh water.
Take out the base plate (6) once a year
following the strap-roller fixing steps on
page 8.
Clean all the parts removed to avoid cor-
rosion and grease (use grease suitable for
marine environment).
Remove any oxide deposits from the ter-
minals of the the reversing contactor unit;
grease them.
24 Screw
25 Grower
26 Pre-torque reduction unit
27 Paper gasket
28 Electric motor 500W
29 Gasket
30 Gasket
31 Motor casing watertight
32 Bottom protec
33 Screw
GB
11