Black and Decker GL7033 Manual Del Usuario página 7

Before using the appliance, check that
u
your cutting path is free from sticks,
stones, wire and any other obstacles.
Only use the appliance in the upright
u
position, with the cutting line near the
ground. Never switch the appliance on
in any other position.
Move slowly when using the appliance.
u
Be aware that freshly cut grass is
damp and slippery.
Do not work on steep slopes. Work
u
across the face of slopes, not up and
down.
Never cross gravel paths or roads
u
while the appliance is running.
Never touch the cutting line while the
u
appliance is running.
Do not put the appliance down until the
u
cutting line has come to a complete
standstill.
Use only the appropriate type of cut-
u
ting line. Never use metal cutting line
or fishing line.
Be careful not to touch the line trim-
u
ming blade.
Take care to keep the mains cable
u
away from the cutting line. Always be
aware of the position of the cable.
Keep hands and feet away from the
u
cutting line at all times, especially
when switching on the motor.
Before using the appliance and after
u
any impact, check for signs of wear or
damage and repair as necessary.
Never operate the appliance with
u
damaged guards or without guards in
place.
(Original instructions)
Take care against injury from any
u
device fitted for trimming the filament
line length. After extending new cutter
line always return the machine to its
normal operating position before
switching on.
Always ensure that the ventilation slots
u
are kept clear of debris.
Do not use the lawn trimmer (edge
u
trimmer), if the cords are damaged or
worn.
Keep extension cords away from cut-
u
ting elements.
Electrical safety
#
This appliance is double insu-
lated; therefore no earth wire is
required. Always check that the
power supply corresponds to the
voltage on the rating plate.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Electric safety can be further improved
u
by using a highsensitivity 30 mA Re-
sidual Current Device (RCD).
Labels on appliance
The following warning symbols are found on the appliance
along with the date code:
Read the manual prior to operation.
Wear safety glasses or goggles when operating
N
this appliance.
Wear suitable ear protectors when operating this
appliance.
ENGLISH
7