Installing/Removing Battery Pack; Adjusting The Nozzle - Ryobi P28014 Manual Del Operador

 Liquids used must be as thin as water. Thicker liquids will
not spray properly.
 Do not overfill the tank.
NOTE: If using a measuring container or funnel to fill the
tank, be sure to thoroughly clean and rinse these items after
use. If premixing the chemical solution, rinse the container
used for mixing.
To fill the tank:
 Remove the battery pack.
 Unscrew the tank from the sprayer.
 Fill the tank with the desired liquid, up to 0.5L (16.9 oz.)
NOTE: To ensure proper operation of the sprayer, DO
NOT overfill the tank.
To reconnect the tank:
 Wipe the outside of the tank with a dry cloth and clean
up any spills before reconnecting the tank.
 Carefully screw the tank back onto the sprayer, making
sure it is tightened securely.
 Reinstall the battery pack.
WARNING:
Fluid may escape from the quick connect if the tank is
not fully drained. Be cautious, and wear the appropriate
protective equipment as specified on the chemicals.
NOTICE:
It is important to thoroughly clean the unit after each use.
Allowing liquid to remain in an idle tool for an extended
period may cause its moving pieces and connectors to
seize up.

INSTALLING/REMOVING BATTERY PACK

See Figure 3.
WARNING:
Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap in place and the battery pack is secured in the
product before beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
OPERATION
Risk of fire or explosion. Spray area must be well-
ventilated and away from sparks or flames.
TURNING THE SPRAYER ON/OFF
See Figure 4.
 To turn the sprayer ON, depress the switch trigger.
 To turn the sprayer OFF, release the switch trigger.

ADJUSTING THE NOZZLE

See Figure 5.
The adjustable nozzle can be adjusted from a stream to a
cone spray.
 Remove the battery pack from the tool.
 Loosen the nozzle for a stream.
 Tighten the nozzle for a cone spray.
USING THE SPRAYER
See Figure 6.
Improper application of cleaning solution can result
in SEVERE INJURY or DEATH. Follow CDC and
EPA guidelines for cleaning. Follow the chemical
manufacturer's safety instructions and guidelines listed
on the SDS sheet and/or EPA Master Label.
Risk of fire or explosion. Spray area must be well-
ventilated and away from sparks or flames.
 Install the battery pack into the tool.
 Direct the sprayer nozzle directly at the plants or objects
you wish to spray.
 Depress the switch trigger to begin spraying/fogging.
NOTE: While the sprayer is in use some dripping from
the nozzle may occur, this is to be expected.
NOTE: Holding the sprayer at an angle could cause liquid
to spurt or stream rather than fog.
 Release the trigger to stop the spray.
 Allow surfaces to air dry. Follow chemical manufacturer's
instructions regarding post-application of surfaces.
 Always refer to the chemical bottle instructions, SDS
sheet and/or EPA Master label for proper dwell time of
chemicals.
8 — English
WARNING:
WARNING:
WARNING: