Connection To A Brick Chimney; Connection To App - Control - ADURO H1 Manual De Instrucciones

2.4 Connection to a brick chimney

If the stove is being connected to a brick chimney, the rear outlet should be used, or a curved flue pipe via
the top outlet. After measurement, a hole is made in the chimney in which the pipe sleeve is placed and
fireplace mortar is used to seal it in place. The stove is placed in position and the flue pipe is put in place. A
thin gasket is placed between the flue pipe and the pipe sleeve to seal the joints. The flue pipe should
protrude 5–10 cm into the pipe sleeve, but must not block the opening in the chimney (see the illustration
below).
The Aduro H1 can be connected to a chimney to which other heat sources are connected.
2.5 Connection to App – control
It is possible to control Aduro H1 in three ways
1. Via the control panel on the stove
2. Via the app Aduro Hybrid 1 in the immediate vicinity of the stove
3. Via the app Aduro Hybrid 1 connected to Aduro Cloud. When your stove is connected to Aduro
Cloud, it is connected to the internet and can be controlled remotely
Access to the Aduro Hybrid 1 App is free, and it can be downloaded from App Store or Google Play. The app
is compatible with IOS versions from 5S and Android versions from 4.1.
44