How Do Ilight The Fire In My Aduro H1 - ADURO H1 Manual De Instrucciones

Ocultar thumbs Ver también para H1:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 93
3.3 How do I light the fire in my Aduro H1?
You can light the fire using just pellets or light it manually with wood – or a combination where you put
firewood in the combustion chamber and use the pellets to light the fire.
Aduro H1 has a damper (see illustration below) where you manually can switch off the air supply to the pellet
combustion. When this damper is closed, the pellet function won't work. This damper is mounted since you
have to shut off air supply to the pellet function in order to obtain the most optimal combustion of wood
pieces. If you use an Aduro H1 with wood and pellets, the damper has to be open (pulled forwards).
NOTE: The first time you light the fire in the hybrid stove, you should use normal firewood because the door
has to stand slightly ajar. This should be done to prevent the gasket from sticking to the paint on the stove.
3.3.1 Lighting the fire manually with firewood
The fire lighting method is very important for starting combustion quickly and efficiently.
1) Open the damper under the door (pulled fully out). The primary damper is used at the start to get the
fire going, while the secondary air intake keeps the fire burning evenly. The illustration below shows
the stove seen from the front with the dampers indicated.
2) Place a log of wood crosswise in the combustion chamber and put 2 firelighters close to the log.
Light the firelighters and quickly put a new log close to the firelighters and several small logs at an
angle above it. Air must be able to reach the firelighters, but the logs should be touching to "warm"
each other.
3) Keep the door approx. 1 cm ajar, until the glass is too hot to touch. Then close the door. When there
are distinct, visible flames and the fire has taken hold, close the primary air intake/damper.
Use edge of door to read position of inlet air
1: Fully open primary-, secondary- and tertiary air inlet. This position can be maintained with the Aduro key,
which must be placed in the two holes.
48

Publicidad

Tabla de contenido
loading

Tabla de contenido