Rowenta DW5000 Instructivo De Operación página 14

1103906895-index 01 DW5000 US_110x220 10/09/10 12:55 Page13
All manuals and user guides at all-guides.com
f there is a problem?
PROBLEM POSSIBLE C USE
Water drips from You are using steam while
the holes in the the iron is not hot enough.
soleplate.
You are using the shot of
steam button too often.
You have stored the iron
horizontally, without
emptying it and without
setting it to
Brown streaks You are using ironing water
come through additives (i.e. scented
the holes in the water, starch).
soleplate and
You are not using the right
stain the linen.
type of water.
Your linen has not been
rinsed sufficiently or you
have ironed a new garment
before washing it.
The soleplate is Your are ironing with an
dirty or brown inappropriate temperature
and can stain the selection (temperature too
linen. high).
You have ironed over a
printed area of a garment.
There is little or The water tank is empty.
no steam.
Your iron has been used
dry for too long.
The soleplate is You have placed your iron
scratched or flat on a metallic rest-plate
damaged. or ironed over a zip.
Steam or water The steam control is not set
come from the to the
iron as you finish
The water tank is overfilled.
filling the tank.
The spray does The water tank is not filled
not spray. enough.
Environnement
Environment protection first !
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a local civic waste collection point.
SOLUTION
Wait until the thermostat light
goes out.
Wait a few seconds between
each use of the button.
See the section "Storing your
iron".
.
Never use ironing water
additives; these will permanently
damage your steam iron.
Perform a Self cleaning
operation and consult the
chapter "What water should I
use?".
Make sure that your laundry is
rinsed sufficiently in order to
remove any deposits of soap or
chemical products on new
clothes.
Clean the soleplate (refer to
chapter 11). Select the
appropriate program.
Never iron over printed areas
or applications – always iron
the reverse side of such a
garment.
Fill the water tank.
Carry out a Self clean.
Refrain from ironing over
metallic buttons or zippers.
Check that the steam control is
position. set to the
Never exceed the Max level.
Fill up the water tank.
13
position.