Service, Storage And Care Of The Powerpacks; Methods For Attaching The Powerpacks - therm-ic PowerPack BasicKids Modo De Empleo

* Measured directly on the heating element under
laboratory conditions
The duration of heating depends on which battery
was selected!
For optimum heat output, Therm-ic recommend the
following batteries or battery pack types.
Alkaline batteries, AAA, 1.5 V
NiMH battery pack, AAA, 1.2 V (rechargeable)
If other types of batteries are used, the heat
produced may not be sufficient for use in very cold
temperatures. When purchasing rechargeable
batteries, please ensure that they are suitable for
use at temperatures below 0°C (32°F) and that
their capacity is smaller than 1000mAh. Your
dealer will be happy to advise you.
13
S E R VI CE, S TORA G E A N D C AR E O F T H E
P O WE R PA C KS
The PowerPacks should be stored at room
temperature in a dry place, switched off (level 0)
and unplugged from the heated insole.
Clean the parts as needed with a soft, slightly
damp cloth and a mild cleanser.
METHODS FOR ATTA CHI NG THE
P O WE R PA C KS
Fix the PowerPack to the outer edge of the shoe
with the wire clip (Fig. 2.1). However, for long-term
use, we recommend one of the attachment options
outlined below.
The PowerPacks can be attached as follows:
 use the Therm-ic Velcro Strap to fix them to the
shoe or lower leg (Fig. 2.2).
 Use the Therm-ic Power strap adapter to fix them
onto the Velcro strap (Fig. 3)