Heating Power - therm-ic PowerPack BasicKids Modo De Empleo

I NS TRUCTI ONS FO R USE / E NG LI SH
the two control buttons (1.2) to adjust the heat
level.
The PowerPacks BasicKids are turned off when all
LEDs on the status display are off.
Turning the device on:
Turning the device off:
Note:
If the PowerPack BasicKids will switch off
automatically when not used for 24 hours.
After the battery has run out of power, the heat
level indication will begin to flicker.
Briefly press the control
button "+" (approx. 1 sec.)
to turn the PowerPack
BasicKids on at the lowest
heat level.
Press and hold (approx. 3
secs.) the control button "-
" (until the status display
turns off) to turn off the
PowerPack BasicKids.
Setting the heat level:
The control buttons on the PowerPacks BasicKids
allow for 3 different levels of heating.
Each time the control button "+" button is pressed
(approx. 1 sec.), the heat level is increased; with
the "–" button (approx. 1 sec.), you can lower the
heat level. The LEDs on the control display show
the current heat level (1 LED = low heat, 3 LEDs =
high heat).
H E A TI N G P O WE R
Level Max.
temperature*
Classic Kids
insole (blue
connector)
(°C / °F)
1 29°C / 84°F
2 39°C / 102°F
3 57°C / 135°F
Max.
temperature*
Therm-ic
insoles (red
connector)
(°C / °F)
37°C / 99°F
45°C / 113°F
70°C / 158°F
12