Kohler K-T461 Guia De Instalacion página 7

Valve
Sleeve Slot
4. Install the Faceplate
CAUTION: Risk of damage to the K-306-KS valve assembly.
When using the K-306-KS HiFlow Valve in a fiberglass or acrylic
installation, use the Thin Wall Installation Kit (88526).
Installing the Stately Faceplate
Remove and discard the plaster guard and/or dome, if installed.
For installation over a tiled wall, apply a bead of silicone sealant
around the back edges of the faceplate.
Fit the backing plate over the valve so the large hole is to the
bottom and secure with two screws. Do not overtighten.
Rotate the valve stem fully counterclockwise.
Position the faceplate over the backing plate and thread the collar
into the backing plate. Do not cross thread.
Insert the sleeve tabs into the collar notches and hand tighten.
Remove the sleeve from the collar and turn it around so the tabs
face outward.
Insert the sleeve into the collar so the slot is down and facing
outward.
Installing the Classic Faceplate
Remove and discard the plaster guard and/or dome, if installed.
Fit the faceplate over the valve and secure with two screws. Do
not overtighten.
Kohler Co.
Stately
Discard plaster guard with dome.
Backing Plate
Screw
Faceplate
Collar
Tab
7
Sleeve
1011157-2-D