Power On/Off; Video Recording - Wiseup DVR-0031-1080P Guia Del Usuario

All manuals and user guides at all-guides.com
III. Operation
>> Before using, make sure that the smoke detector camera is fully recharged.
>> Please make sure the Micro SD card (4GB-32GB, format it for the first usage) is
securely fitted into the camera's SD card slot, or it will not work. A SDHC Class 10
Micro SD card is recommended. If the Micro SD card cannot be read, the camera
will not respond correctly to your operation.

3.1. POWER ON/OFF

3.1.1. Slide the power switch to the ON position. Power on the camera by pressing
the Power Button for 3 seconds. The blue indicator light will stay illuminated, indicat-
ing the camera has entered into standby mode automatically.
3.1.2. Power off the camera by pressing the Power Button for 3 seconds again. The
blue indicator light will turn off. Slide the power switch to the OFF position.
[Note]:
The camera will shut down automatically if it is in standby mode without any operation more
than 1 minute.

3.2. VIDEO RECORDING

3.2.1. Slide the power switch to the ON position. Power on the camera by pressing
the Power Button for 3 seconds. The blue indicator light will stay illuminated, indicat-
ing the camera has entered into standby mode automatically.
3.2.2. Press the Video Recording Button once to record video. The blue indicator
light will flash once and then turn off.
3.2.3. Press the Video Recording Button once again to stop recording video. The
blue indicator light will stay illuminated, indicating the camera is back to standby
mode.
[Notes]:
1). A video file will be generated and saved every 10 minutes automatically.
2). The smoke detector camera can record video continuously for 2.5 hours on a full charge.
3).Video Resolution: 1920×1080P Video Format: AVI
3.3. CAMERA/STILL PHOTOGRAPHY
3.3.1. Slide the power switch to the ON position. Power on the camera by pressing
the Power Button for 3 seconds. The blue indicator light will stay illuminated, indicat-
ing the camera has entered into standby mode automatically.
3.3.2. Press the Camera Button once to take a photo. The blue indicator light will
flash once and then stay illuminated, indicating the camera is back to standby mode.