Indesit CTAA 55 NF WD Manual Del Usuario página 27

III. Installation
1. Installation of water valve components
The guiding boss on the water valve components
shall be in alignment with the guiding slot on the
base, and press it down in the direction of in the
direction of 45°of oblique downward by hands with
strength, until you may hear the sound of "lick".
2. Installation of water tank sealing ring
To install the sealing ring on the bottom of water
tank by hand, make sure that it is properly installed,
and the wrinkling and oblique installation and so on
shall be avoided.
3. Installation of water tank components
The hanging slot on the water tank components
shall be in alignment with the suspension loop
on the inner layer, and the sealing ring at the
bottom of water tank shall be in alignment
with the entrance of water value components,
and then insert them into the corresponding
positions in the direction of 45° of oblique
downward by hands.
REFRIGERATOR-FREEZER
Cleaning of water receiving tank
Use wet cloth to wipe it and then use the dry
cloth.
10