Power Supply Cord Connection - Whirlpool WETLV27HW Instrucciones De Instalación

Power Supply Cord Connection

Power Supply Cord Strain Relief
1.
Attach power supply cord
strain relief
Remove the screws from a 3/4" (19 mm) UL Listed strain
relief. Put the tabs of the two clamp sections (C) into the
hole below the terminal block opening (B) so that one tab
is pointing up (A) and the other is pointing down (D), and
hold in place. Tighten strain relief screws just enough to
hold the two clamp sections (C) together.
2.
Attach power supply cord
to strain relief
Put power supply cord through the strain relief. Be sure that
the wire insulation on the power supply cord is inside the
strain relief. The strain relief should have a tight fit with the
dryer cabinet and be in a horizontal position. Tighten the
strain relief against the power supply cord. Do not overtighten
the strain relief screws.
If your outlet looks like this:
Power supply cord 4-wire receptacle
(NEMA Type 14-30 R):
Go to "4-Wire Power Supply Cord
Connection" on this page.
Power supply cord 3-wire receptacle
(NEMA Type 10-30 R):
Go to "3-Wire Power Supply Cord
Connection" on page 17.
16
4-Wire Power Supply Cord Connection
IMPORTANT: A 4-wire connection is required for mobile
homes and where local codes do not permit the use of 3-wire
connections.
A
B
4-wire receptacle
(NEMA type 14-30 R)
C
D
Spade terminals with
upturned ends
1.
Prepare to connect neutral
bond wire and neutral wire
Remove center terminal block screw (B). Remove neutral bond
wire (E) from external ground conductor screw (A).
2.
Connect neutral bond wire
and neutral wire
Connect neutral bond wire (E) and neutral wire (white or center)
(C) of power supply cord under center terminal block screw (B).
Tighten screw.
4 prong plug
Ring terminals
E
B
A
E
B
C