Whirlpool WETLV27HW Instrucciones De Instalación página 22

Lavadora/secadora eléctrica de 24" (61 cm) y eléctrica y de gas de 27" (69 cm)
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Power Supply Cord Connection
Power Supply Cord Strain Relief
1.
Attach power supply cord
strain relief
Remove the screws from a 3/4" (19 mm) UL Listed strain
relief. Put the tabs of the two clamp sections (C) into the
hole below the terminal block opening (B) so that one tab is
pointing up (A) and the other is pointing down (D), and hold in
place. Tighten strain relief screws just enough to hold the two
clamp sections (C) together.
A. Strain relief tab pointing up
B. Hole below terminal block opening
C. Clamp section
D. Strain relief tab pointing down
2.
Attach power supply cord
to strain relief
Put power supply cord through the strain relief. Be sure that
the wire insulation on the power supply cord is inside the
strain relief. The strain relief should have a tight fit with the
dryer cabinet and be in a horizontal position. Do not further
tighten strain relief screws at this point.
22
A
B
C
D
4-Wire Power Supply Cord Connection
IMPORTANT: A 4-wire connection is required for mobile
homes and where local codes do not permit the use of
3-wire connections.
4-wire receptacle
(NEMA type 14-30 R)
Spade terminals
with upturned ends
4 prong plug
Ring terminals

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Wet4124hw

Tabla de contenido