OPERATION
WARNING: Electrical Hazard. Do Not Operate
With Damaged Power Cord. Do Not Modify Plug.
Unplug power Cord Before Servicing Machine.
If the supply cord is damaged or broken, it must
be replaced by the manufacturer or it's service
agent or a similarly qualified person in order to
avoid a hazard.
CLEANING APPLICATION
FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
ATTENTION: The machine is designed to clean
water- -resistant surfaces only; such as concrete,
ceramic tile, quarry tile, glass, sinks, urinals,
toilets, restroom partitions, showers, pipes,
mirrors and other areas subject to soap, mineral
deposits and daily soils.
Cleaning Application is not recommended on
painted plaster board/dry wall and wall papered
surfaces.
Contact your local distributor for recommended
cleaning agents for cleaning kitchens, stair wells,
windows, etc.
ATTENTION: Floors should be sealed to prevent
water seepage. Inspect all grout lines, seams,
corners, etc. for cracks. Repair as needed. We are
not responsible for any water damage.
Safety goggles, protective gloves and protective
clothing (not supplied) are required while cleaning.
Safety goggles must be designed to protect eyes from
liquid splash (Figure 8).
FOR SAFETY: Do not operate machine, unless
safety goggles are worn.
FIG. 8
10
Home
Find... Go To..
A:
PREPARING AREA
1. Sweep area of debris.
2. Remove trash containers from room.
3. Remove exposed paper products from room.
4. Dust clean overhead fixtures and vents. Machine
is designed for dust cleaning (See OTHER
CLEANING USES WITH MACHINE).
5. Flush all fixtures in restrooms and keep lids open
on toilets.
6. Protect all electrical outlets, switches, fuse boxes,
and connective devices with waterproof shields.
7. Cover any exposed item that you do not want to
get wet.
8. Position machine in doorway to block access to
area.
9. Use a door stop to prevent hose damage. Do not
close doors on hoses.
FOR SAFETY: Before operating machine, place
"WET FLOOR" signs as needed.
B:
APPLYING CLEANING AGENT (FORMULA 710)
1. If area is not equipped with a floor drain, connect
black recovery hose at front of machine, attach
gulper tool and place tool where water may puddle
when operating (Figure 9).
FIG. 9
Quick Clean 1500 (06- -05)