Descargar Imprimir esta página

Filling Solution Tank; Connecting Power Cord To Wall Outlet - Nobles QUICK CLEAN 1500 Manual De Operador

Ocultar thumbs Ver también para QUICK CLEAN 1500:

Publicidad

Idiomas disponibles

Idiomas disponibles

FILLING SOLUTION TANK

Each new machine is equipped with two sample
quarts (1.9 L) of Formula 720 Multi--Surface Rinse.
The rinse formula should be added to the solution tank
before operation. Formula 720 is intended to be used
for rinsing surfaces after cleaning to reduce water
spotting and speed drying. To order additional Formula
720, contact your supplier.
ATTENTION: Use of unapproved or inappropriate
chemicals may cause damage to machine and
surfaces and could void your warranty
FOR SAFETY: When using machine, follow
mixing, handling, and disposal instructions
provided on chemical container instructions and
MSDS sheets.
1. Remove front solution tank lid from machine. Add
Formula 720 Rinse or approved substitute to the
tank as per dilution instructions on bottle (Figure 4).
FIG. 4
2. Connect fill--hose (supplied with machine) to water
faucet and fill tank with 15 gallons (56 L) of clean
water (Figure 5). If using hot water, do not exceed
140° F / 60° C.
WARNING: Fire or Explosion Hazard. Never
Use Flammable Liquids Or Operate Machine In Or
Near Flammable Liquids, Vapors Or Combustible
Dusts.
FIG. 5
Quick Clean 1500 (06- -06)
Home
Find... Go To..
3. Replace solution tank lid after filling.

CONNECTING POWER CORD TO WALL OUTLET

1. Connect power cord into a grounded wall outlet
(Figure 6). Use a wall outlet outside the area to be
cleaned.
Grounded
3 Hole Outlet
Ground Pin
(120V)
FIG. 6
FOR SAFETY: Do not operate machine unless
cord is properly grounded.
FOR SAFETY: Do not operate machine with the
use of an extension cord .
2. The power cord is equipped with a Ground Fault
Circuit Interrupter device (Figure 7). The GFCI
protects the user against electrical shock (120V
Models Only).
Test GFCI device before each use.
a. Verify that the indicator is red.
b. Press test button, red indicator should
disappear.
c. Press reset button. If test fails, do not use
machine. Call an authorized service
representative for assistance.
FIG. 7
WARNING: The Ground Fault Circuit
Interrupter (GFCI) does not protect user against
electrical shock due to contact with both circuit
conductors or a fault in any wiring supplying this
device. Do not use extension cord between GFCI
and power outlet.
OPERATION
Grounded Outlet
Grounding
Edge/hole
(220V/230V/240V)
9

Publicidad

loading