Getting Started - Ribimex Ribiland PR4EN1T Manual De Instrucciones

ENGINE
I. Parts List
1. Engine housing
2. Spark plug
3. Recoil starter
4. Air filter assembly
5. Fuel tank
6. Wiring
7. Shaft
8. Handle
9. Throttle trigger
10. Throttle lockout lever
11. Throttle lock button
12. Ignition switch
II. CHARACTERISTICS
Engine model
Engine type
Bore x Stroke
Displacement
Engine Speed at idle / max
Compression ratio
Fuel/oil Ratio
Fuel tank capacity
Ignition
Spark plug
Starting method
Cooling system
Sound pressure level (measured / guaranteed)
Sound Power level (measured / guaranteed)
Vibration level (idle / running / max.)
Dry weight
III. Special Safety Instructions
See below
IV. GETTING STARTED
4.1- Installing the Powerhead
1. Place the powerhead on a clean, flat surface, spark plug facing up.
2. Use the 4mm Allen wrench (Hex-key) to loosen the tube clamp as shown in fig.E1
3. Slip off the protective covers from two ends of tube
4. Push the lower tube towards the tube clamp and rotate it by hand to check that the main shaft
splines engage the powerhead, See Fig.E2
5. Insert the lower tube into the tube clamp until it bottoms and align the
positioning holes on the tube and clamp, then install the screw.
6. Fasten the clamp securely with 2 clamp screws.
All manuals and user guides at all-guides.com
1E34F
2-cycle, air-cooled, vertical cylinder
34 x 28mm
25.4cm3
-1 -1
3100 min / 8000min
7:1
25:1 with 2-cycle
700ml
CDI system
BM6A or L8RTF or equivalent
Recoil (manual)
Forced air
95dB / 99dB (K=3dB)
111dB / 115dB (K=3dB)
2 2
4,71m/s / 5,83m/s / 7m/s
5.9kg approx.
2