Ribimex Ribiland PR4EN1T Manual De Instrucciones página 43

Fig. E6
1. Cable adjuster nut
1. Idle Throttle Position;
2. Stop on throttle body;
3. Full throttle position.
4.5- Mixing fuel
1. Use only fresh, clean unleaded gasoline with an octane rating of 87 or above.
2. Mix all fuel with 2-cycle Engine Oil at a gasoline/oil ratio of 25:1
CAUTION! This engine is to be operated on a 25:1 mixture consisting of unleaded gasoline and
2-cycle mixing oil only.
Some gasolines contain alcohol as an oxygenate! Oxygenated fuels may cause
increased operating temperatures. Under certain conditions, alcohol-based fuels may
also reduce the lubricating qualities of some mixing oils. Never use any fuel containing
more than 10% alcohol by volume! When an oxygenated fuel must be used, fuel
containing an oxygenate such as MTBE is to be preferred over an alcohol based fuel.
Generic oils and some outboard motor oils may not be intended for use in
high-performance air cooled 2-cycle engines, and should never be used in a this engine
Important! Mix only enough fuel for your immediate needs! If fuel must be stored longer than 30
days, it should first be treated with a stabilizer
4.6- Filling the fuel Tank
1. Place the tank on a flat, level surface.
2. Clear any dirt or other debris from around the fuel filler cap.
3. Remove the fuel cap, and fill the fuel tank with clean, fresh fuel mixture.
4. Install and firmly tighten the fuel cap.
All manuals and user guides at all-guides.com
1. Throttle free play 6mm
Fig.E8
Fig.E7