Uline H-5334 Manual De Instrucciones página 3

OPERATING ISSUE
No power to machine.
Paper not pulling through head.
Paper exposed in exit shoot, but
not being pulled through with foot
pedal operation.
Paper jamming.
Paper ripping during operation.
If problems persist, please contact Uline Customer Service at 1-800-295-5510.
PAGE 3 OF 9
TROUBLESHOOTING
CAUSE
Unit not plugged in.
Motor not connected to power
box.
Machine needs to be reset.
Foot pedal not connected to
power box.
Paper wadded in entrance
funnel, not flat.
Paper is caught or not threaded
through enough.
Insufficient drive wheel tension.
Not using recommended paper.
Restriction in the entrance or exit
funnel.
Not using recommended paper.
Live roller on cradle is not rolling
freely.
Continuous, back-to-back, short
bursts of paper using the pedal.
Too much drive wheel tension.
1-800-295-5510
uline.com
RECOMMENDATIONS
Connect power cord to standard
115V outlet.
Connect blue motor connector
plug to the blue plug on the power
box; make sure it has clicked into
place.
Check white two amp reset button
on power box to make sure it is
recessed.
Connect the gray foot pedal
connector plug to the gray plug
on the power box; make sure it has
clicked into place.
Make sure paper is flat and folded
in on itself in the entrance funnel.
Turn threading disk clockwise to
advance paper.
Tighten the bolts on the top of the
head a quarter turn at a time.
Repeat as needed until drive
wheels grip paper.
Use only 30 lb. or 40 lb. kraft paper
with machine.
Unplug unit and retrieve any debris
or jammed paper from the machine
by tearing the paper from the
paper ramp and turning threading
disk clockwise.
Use only 30 lb. or 40 lb. kraft paper
with machine.
Paper roll needs to be unspooled
from the rear of the paper cradle.
Use gentle foot pedal operation,
avoid stepping on the foot pedal
with extreme force.
Loosen the bolts on top of the head
a quarter turn at a time. Repeat as
needed until drive wheels are no
longer ripping the paper.
0521 IH-5334