Lista De Comprobación De La Seguridad En La Planificación Del Emplazamiento - LiftMaster HDSL24UL Manual De Instalación

Operador de compuerta corrediza comercial a cc para vehiculos
Tabla de contenido

Publicidad

Swing and Slide Gate Operator UL 325 and
ASTM F2200 Site Planning Safety Checklist
Please Print
Name:
Address:
City/State/ZIP:
Gate Safety Check —
UL 325 Standard
1. Gate Operator is approved to current UL 325 standards (check operator label)
2. Proper gate warning signs attached to both sides of gate area
3. All entrapment zones protected by 2 safety devices/obstruction tested
Close Side
(circle two)
Photo Eye
Open Side
(circle two)
Photo Eye
Other Entrapment Zones
*Entrapment Zone: The location where a person can be caught or held in a position that increases the risk of injury
ASTM F2200 Standards
Gate Construction Evaluation: Gate Constructed with Safety in mind. ASTM F2200 Standards are followed
All Gates
Gates have smooth bottom edges, no protrusions exceed 1/2" beyond base of gate
All access controls at least 6 ft. from gate
Barbed tape (razor wire) at least 8 ft. above grade
Barbed wire at least 6 ft. above grade
Separate pedestrian gate – out of reach of a moving gate – vehicular gate is
for automotive traffi c only
Gate does not move on its own if disconnected from operator
Gates prevented from falling over if disconnected from supporting hardware
SWING
Distance from pivot point to column edge is less than 4 in. or external
entrapment protection is provided
Distance from open gate to wall, column, or other fi xed object is greater than
16 in. or external entrapment protection is provided
SLIDE
Roller covers on weight bearing exposed rollers 8 ft., or less, above grade
Meshing installed up to 6 ft. above grade if pickets spaced equal to or
greater than 2 1/4 in. apart
Gap between gate and fence post less than 2 1/4 in. & gap protected with safety device
Positive stops at both fully open and fully closed positions
Receiver guides recessed behind receiver post for receiver guides less than 8 ft.
Other:
Please Print
First & Last Name of Dealer:
Name of Dealership:
Dealership Address (Street Address/City/State/Zip):
Dealer Signature:
Customer Signature:
© 2021 LiftMaster All Rights Reserved
300 Windsor Drive, Oak Brook, IL 60523
LMSPCLSWSL
12/19
Satisfactory
Simple steps to quickly determine if an End User's gate operator is safe.
Component:
Reversing Edge
Inherent Reverse
Reversing Edge
Inherent Reverse
Component:
Phone:
Email:
Needs Repair/Replacement
Result (Circle)
Comments:
Pass
/
Fail
Pass
/
Fail
Pass
/
Fail
Pass
/
Fail
Pass
/
Fail
Result (Circle)
Comments:
Pass
/
Fail
Pass
/
Fail
Pass
/
Fail
Pass
/
Fail
Pass
/
Fail
Pass
/
Fail
Pass
/
Fail
Pass
/
Fail
Pass
/
Fail
Pass
/
Fail
Pass
/
Fail
Pass
/
Fail
Pass
/
Fail
Pass
/
Fail
Pass
/
Fail
First & Last Name of Installer:
Phone:
Installer Signature:
Figures (On Back)
1,4
1,4
Figures (On Back)
5
1,4
1,4
4
4
1
3
2
1

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Csl24ul

Tabla de contenido