Step 2: Connect The Cable - SPX Nemisys Guia De Inicio Rapido

Test Startup and Vehicle Connection

Step 2: Connect the Cable

IMPORTANT: Make sure you have correctly entered the vehicle
information in the scan tool; incorrect vehicle identification can produce
unexpected test results (see
page 8).
Note: Leave the Required Cables screen displayed on the scan tool. Do not turn the
scan tool off.
Figure 11: Vehicle DLC Cable Connections to Scan Tool and Vehicle DLC
1 Connect the cable's 25-pin connector to the DB25-pin port on the top of the scan
tool and connect the other end to the vehicle's DLC, as shown above.
Note: The vehicle's DLC is not always located under the dash as shown.
Some vehicles may have more than one connector or may have test leads
instead of a connector. Whatever the case, make the required connections
to the vehicle's DLC. For some vehicles, accessory cables and adapters
may be required (see Accessory Components in the User Guide.)
2 Place the vehicle's ignition key in the On (or Run) position. Do not start the engine.
3 If the external power indicator (
lighter power adapter, as shown in
Note: Generally, the standard OBD II cable connection supplies power to
the scan tool. If you are using the standard OBD II cable and the indicator
is not lit, make sure the cable is connected securely.
10
"Step 1: Enter the Vehicle
) on the scan tool is not lit, connect the cigarette
Figure 12.
English
Information" on
Quick Start Guide