Step 4: Select The Diagnostic Function - SPX Nemisys Guia De Inicio Rapido

Step 4: Select the Diagnostic Function

After you connect the cable and press the ENTER key on the scan tool, use
the following steps if either an instructional message screen or the Diagnostic
Menu screen appears (shown below). In addition, for OBD II vehicles, use the
following steps after you have viewed the Quick Test results screen
on page 12) and pressed the ENTER key.
Figure 14: Message Screen and Diagnostic Menu Screen
1 If one or more Message (Warning) screens appear, follow the on-screen instructions
or press the ENTER key to continue. Do this until the Diagnostic Menu screen
appears, as shown above.
2 Select a diagnostic function and press the ENTER key.
Note: The Diagnostic Menu screen shown above is only an example that
shows all possible options. During testing, only the options available for the
vehicle and ECM being tested will appear on this screen.
3 Refer to the brief descriptions on the next page. For detailed instructions,
refer to the User Guide.
Quick Start Guide
Test Startup and Vehicle Connection
English
(Figure 13
13