Brita On Line Active Manual De Instrucciones página 5

3 On Line Active Kit – easy installation
Before starting, please check that you have all the components as
listed above (see fi g. 1) as well as the recommended tools.
There are 5 steps to the installation.
Prior to installation, read the Technical Data (chapter 7) and
the Important Information (chapter 9). After storage and
!
transport below 0°C, the product must be stored in the open
original packaging for at least 24 hours at the stated ambient
temperatures (chapter 7) for operation.
3.1 Step 1: Programming the electronic
BRITA cartridge exchange indicator
A Commissioning:
Please insert the enclosed batteries (2 x AA) into the appropriate
compartment of the electronic cartridge exchange indicator with
display. A long beep will sound after insertion of the batteries.
B Initial Programming:
Important: Please program the timer on your product for 180 days.
Caution: Please ensure that you activate the electronic BRITA
cartridge exchange indicator with display during the day so that the
signal can start during the day.
Programming:
a Press the DISPLAY button briefl y to activate the display. Initially,
the default setting of 90 days is displayed.
b Press and hold the DISPLAY button and then press the START/
RESET button briefl y at the same time. This activates the setting
mode.
c To switch from 90 days to 180 days, press the DISPLAY button
briefl y.
d Wait until the time value stops fl ashing or the DISPLAY switches
off.
e To activate the 180-day timer, briefl y press DISPLAY and then
press the START/RESET button.
f A fl ashing spot in the bottom left of the display indicates that the
timer is active.
All manuals and user guides at all-guides.com
C Reading the timer status
The display is activated by pressing the DISPLAY button briefl y
during operation.
The remaining time since the new cartridge was inserted is shown
in days.
If the time is exceeded, the time is displayed with a minus sign.
D Audible signals
a Signal to replace the cartridge: A long signal sounds on the
hour every hour when there are less than 10 days before
the end of the programmed 90 or 180 day setting (15 double
beeps). A shorter reminder (5 double beeps) then sounds every
15 minutes until the next signal.
b Reminder function: Press any button to deactivate the signal for
72 hours if you prefer to be reminded to replace the cartridge at
a later date.
c Battery signal: When the batteries are depleted, a long signal
sounds (15 single beeps) followed by a short reminder signal
(5 single beeps) every 15 minutes until the next signal on the
hour.
d Switching the device off: This is only possible by removing the
batteries from the battery compartment
E Activating the reset function when replacing the
cartridge
a Press the DISPLAY button briefl y to activate the display.
b Press and hold the START/RESET button for 5 seconds until a
long beep sounds.
c The last 180 programmed days appear in the display.
d The timer starts automatically.
F Changing the batteries
a After changing the batteries, a long beep sounds.
b After the beep, briefl y press the DISPLAY button to activate the
display.
c The remaining days since the last reset are now displayed.
( Caution: Only possible up to 16 hours after the batteries are
fully depleted. After this time, the device reverts back to the fac-
tory setting and must be reprogrammed – see point B).
G Installation
You can fi x the electronic cartridge exchange indicator to an appro-
priate and dry place by using the supplied hook and loop fastener.
We recommend installing it under the sink. Avoid contact with
water/splashes!
5
ENGLISH