Uline H-2560 Manual De Instrucciones página 2

4. Twist center support of base so it is flush with bottom
board. Insert 3" deck screw into predrilled hole
through bottom board. Repeat on each base.
(See Figure 3)
Figure 3
5. Position the seat assembly approximately 10-15" off
the floor. A five gallon bucket under the center works
well. (See Figure 4)
Figure 4
6. Insert a base support in the open space of each of
the three support arms, centering each leg on the
predrilled countersunk holes of the support arms.
Loosely attach the base support uprights to the
support arms with 3½" lag screws and flat washers.
Do not fully tighten at this step. (See Figure 5)
Figure 5
PAGE 2 OF 9
ASSEMBLY CONTINUED
7. Place the tabletop on top of table to align with the
holes of the base. Make sure the support arms are
centered. (See Figure 6)
8. Loosely attach each base to the tabletop and
support arms using the 3½" lag screws and washers
with the power drill and 7/16" socket bit (will tighten
later in step 11).
9. Loosely attach the pre-drilled holes of the seat to
the support arms using 12 of the 3½" lag screws and
12 washers with the power drill and 7/16" socket bit
(will tighten later in step 11). (See Figure 7)
10. Use the 2½" lag screws to loosely attach base to
the seat (will tighten later in step 11). Use a tape
measure to ensure that the seat is centered and 2"
from base. Make sure the seat is pressed flat against
the base. (See Figure 8)
Figure 6
Centered
Support
Arms
Figure 7
Figure 8
0721 IH-2560