Hot Air Delivery Connection - Palazzetti INSERIMENTI A70 Manual De Instrucciones

7.3.1 Insertion of room sensor
The sensor must be installed near the side or
front suction holes of the cladding base.
Glue the probe wire in correspondence with the
air intakes

7.4 Hot air delivery connection

Only for the channelled model.
7.4.1 Hood liner fitting for heating in a single
room
• Take the flexible pipe at the ends and stretch it,
accompanying it with a twisting motion.
• Cut it to the desired length (no more than 200
cm) and mount the vents in the desired points.
• Fasten the tube (1) to the collars (3) with the
clamps (2)
• Insulate the pipes with insulating material.
68
The vents are fixed on the hood or on
a wall at a height of at least 1.8 ÷ 2.0 m
Fig. 30
from the floor in order to prevent that
the outgoing hot air invests people.
IT is not recommended to have ducts longer
than 7÷8 m.
7.4.2 Channelled pipelines fitting for heating
in multiple rooms
To heat several rooms, it is possible to create
metal pipelines for air distribution according to
the following diagram:
• flexible aluminium hose - maximum length 7÷8
m per duct;
• smooth metal pipe or canalisation - length up
to 12 m on a single pipe; of 8÷9 m on double
duct.
Install a vent in the same room as the fireplace
and the second in another room of the house.
IT is possible to connect the hot air delivery with
Fig. 31
a flexible pipe up to the mouth of the distribution
channels.
The air distribution ducts must have an internal
section of 20×20 cm and be made of smooth
galvanised sheet metal and insulated 30 mm
insulating material to avoid noise and heat
dispersion.
When the fireplace is used to heat two
or more adjacent rooms, it is essential
to promote the recirculation of ambient
air to even out the temperature in the
different rooms, therefore provide the
doors with grilles or keep them ajar.
1
3
2
Fig. 32
004778740 - 14/06/2021