Use Instructions For Accessory Discs In The Continuous Feed Chute - Waring Commercial VCM1000SK Manual De Instrucciones

run continuously until you have fine powder. Cheese with high moisture content
can ball up if processed too long.
Chop Onions, Celery, Cabbage, etc.
Cut onions in quarters, and other vegetables into 50.8mm or 76.2mm cubes.
Place the cubed food into the work bowl up to the top of the bowl's inner tube,
and pulse until you reach the desired consistency.
Note: If you let the blade run too long, the ingredients on the bottom will
become puréed or give you uneven results.
Purée or Mix
To purée tomatoes, vegetables and fruits, make sauces, or mix and blend
ingredients, place the ingredients in the bowl, turn the unit on and allow it
to run continuously until you reach the desired consistency. Do not let the
machine run unattended. If your recipe exceeds more than 1.7 liters of wet
ingredients, please process in several batches.
TURN THE MACHINE OFF WITH THE OFF SWITCH.
• Always switch the food processor off by pressing and releasing the PULSE/
OFF ( ) switch. This assures that the power is not supplied to the motor.
The Red LED will remain on as long as unit is plugged in.
• Always switch the food processor off and wait until rotation stops before
removing the cover.
• The safety interlock switch will turn the machine off if the cover is rotated
clockwise or if the cover is removed while running, but this should not be the
means of ON/OFF (
• Before rotating the lid, always make sure the machine is off by pressing the
PULSE/OFF (
machine was not turned off properly.
• When processing, it is recommended that the machine be operated on a 50%
duty cycle, such as 5 minutes on / 5 minutes off. This can be accomplished
by processing for 5 minutes, then doing 5 minutes of food preparation.
Please remember to turn off the machine when not in use.
USE INSTRUCTIONS FOR ACCESSORY DISCS IN THE
CONTINUOUS FEED CHUTE – VPA1000K
• Assemble the continuous feed chute and accessory disc as instructed in the
section titled "Assembling the Continuous Feed Chute Parts" page 5.
• If required by your processing task, either:
Stack the feed tube with food product and position the large food pusher at
the top of the stack, or
Place the large food pusher into the feed tube and remove the small feed
pusher to use the smaller feed chute located inside the large food pusher.
All manuals and user guides at all-guides.com
) operation.
) lever as a safety precaution, in the event that the
10