Bosch PSB 600 RE Manual De Instrucciones página 11

Auxiliary Handle/Depth Stop
When drilling use the auxiliary handle 10.
The auxiliary handle can be mounted on the left
or right side of the spindle collar, using the
winged screw 9.
The drilling depth can be set with the depth
stop 11.
For this, press button 8 and pull the depth stop
out parallel until it protrudes as far as the drill tip.
Adjust the read scale value minus the required
drilling depth X on the scale.
Drill Spindle Lock Button
Before any work on the machine itself, pull
the mains plug.
For changing the tools or the drill chuck easily
and quickly, the machine has a drill spindle lock-
ing facility thus eliminating the need to hold the
drill spindle by hand or by using a tool.
For this purpose, press down the spindle lock
button 2 and turn the chuck slowly by hand until
the drill spindle can be felt to lock and the chuck
is blocked.
Press the spindle lock button only when at a
standstill.
Inserting the Tool
Open the drill chuck until the tool can be inserted.
Insert the tool.
Keyless Chuck (see figure
Lock the chuck by pressing the spindle locking
button 2 and hold pressed. Open the chuck wide
enough so that the tool can be inserted.
Pressing the spindle retention key, open the
sleeve of the chuck by turning it hard with your
hand until you don't hear a "click" any longer. This
is the way to lock the chuck automatically.
The locking is released again when the front col-
lar is turned in the opposite direction to remove
the tool.
11 • 2 609 932 184 • 02.07
All manuals and user guides at all-guides.com
Caution! The chuck may be very hot:
During longer working periods, especially
when impact drilling, the chuck can become
very hot. In this case we recommend wearing
protective gloves.
Key chuck (see figure
Clamp evenly in all three holes with the chuck
key 12.
Observe correct mains voltage: The voltage of
the power source must agree with the voltage
specified on the nameplate of the machine.
Equipment marked with 230 V can also be con-
nected to 220 V.
Switching On and Off
To start the machine, press the On/Off switch 5
and keep it depressed.
Lock the pushed On/Off switch 5 by pressing the
lock-on button 4.
To switch off the machine, release the On/Off
)
A
switch 5 or push and release it then.
Speed Preselection
(PSB 600 RE/PSB 640 RE/
PSB 650 RE/PSB 700 RE)
The required speed can be preselected with
thumbwheel 6 (also while running).
English - 3
Initial Operation
The machine runs with variable
speed between 0 and maximum, de-
pending on the pressure applied to
the On/Off switch 5. Light pressure
results in a low rotational speed thus
allowing smooth, controlled starts.
Do not strain the machine so heavily
that it comes to a standstill.
(PSB 600 RE/PSB 640 RE /
PSB 650 RE/PSB 700 RE)
)
B