Sony Walkman Atrac3plus D-NE9 Manual De Instrucciones página 34

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Troubleshooting
Symptom
The CD does not play or
"No disc" appears in the
display when a CD is placed
in the CD player.
CHARGE lamp flashes on the
CD player when you press a
button, and the CD does not
play.
Cannot adjust the volume
with VOL +/– on the CD
player.
During recording with optical
digital connection, the track
number cannot be recorded
correctly.
The rechargeable batteries
cannot be charged.
Playback starts from the
point you stopped. (resume
function)
Rustling noise is heard from
the CD.
When using with a connected
stereo system, the sound is
distorted or noisy.
34
-GB
Cause and/or corrective action
c The buttons are locked. Slide the HOLD switch back. (page 25)
c The CD is dirty or defective. (page 32)
c Check that the CD is inserted with the label side up. (page 13)
c Moisture condensation has occurred.
Leave the CD player aside for several hours until the moisture
evaporates.
c Close the lid of the battery compartment firmly. (page 28)
c Make sure the batteries are inserted correctly. (pages 28, 30)
c Connect the AC power adaptor to an AC outlet securely. (page 13)
c Press the jog lever after one second or more has passed since the
AC power adaptor was connected.
c The CD-R/RW is blank.
c There is a problem with the quality of the CD-R/RW, recording
device, or application software.
c Files in two or more formats have been recorded on the same CD-
R/RW. (page 7)
c The buttons are locked. Slide the HOLD switch back. (page 25)
c The CD player is connected to an audio device. Adjust the volume
using the volume control on the connected device. (page 27)
c Record the track number again using a MiniDisc recorder, DAT
recorder, etc. (page 27)
c See the instruction manual that comes with the recording device.
(page 27)
c The CD is playing. Stop playing.
c The external battery case is connected to the CD player. Remove it
and start charging again.
c The resume function is working. To start play from the first track,
press the jog lever during stop until the first track starts playing, or
open the lid of the CD player. Or remove all power sources, then
insert the batteries or connect the AC power adaptor again.
(pages 13, 28, 30)
c Close the lid of the battery compartment firmly. (page 28)
c Adjust the volume of the connected device. (page 27)

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido