Operation - cecotec Ready Warm 8100 Power Quartz Manual De Instrucciones

Assembly diagram
• Mark the hole positions using a pencil and drill 4 holes into a suitably strong exterior wall
by positioning the wall bracket (2) a minimum 2 m above the ground. Ensure the holes are
straight by using a spirit level (not included). Using an impact drill (not included), bore the
holes in the positions you have just marked.
• Insert 4 universal wall plugs (C) into the drilled holes. Insert 4 screws (B) into the wall
plugs. Attach the bracket to the heater (1) using 3 screws (A) inserting these into the
threaded holes on the back of unit.
• Hang the bracket onto the 4 screws in the wall.
• Before plugging the heater into a power supply, first adjust the angle of the heater. Only
change the angle of your heater when it is not in use and it is completely cool.

5. OPERATION

1. Connect the device to a power supply.
2. Pull from the pull chain switch to turn the device on. The slight vibration noticeable
when the appliance is switched on will stop after a few seconds.
3. Select the desired power level:
a. Position 0: Stop
b. Position 1: 650W (low power)
c. Position 2: 1350W (medium power)
d. Position 3: 2000W (full power)
READY WARM 8100 POWER QUARTZ
ENGLISH
37