Worx WX527 Manual Del Usuario página 15

used dependant on the following examples and other
variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained
Using the correct accessory for the tool and ensuring it is
sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating cycle
such as the times when the tool is switched off and when
it is running idle but not actually doing the job. This may
significantly reduce the exposure level over the total
working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE:
The tool is intended for ripping and cross-cutting wood
and other materials in straight cutting lines, while resting
firmly on the work piece.
ASSEMBLY AND OPERATION
Action
BEFORE OPERATION
Removing the battery pack
Charging the battery
Installing the battery pack
ASSEMBLY
Saw blade Assembly and
Removing
WARNING: Always
remove the battery
before changing the blade!
Lithium-Ion Cordless Circular Saw
Figure
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. B
Safety On/Off Switch
WARNING:To avoid
cutting injury from the
sharp blade, please don't put
your hands around the Base
Plate.
NOTE: Keep the dust adapter
connected to dust collecting
device when using the tool.
Cross and Rip Cutting
NOTE: To avoid injury from
Kickback, please don't start
cutting until the blade runs stably.
Cutting Depth Adjusting
Parallel Guide
Pocket Cutting
Sawdust Removal
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes too hot, please run your circular
saw no load for 2-3 minutes to cool the motor. Avoid
prolonged usage at very low speeds.
Protect saw blades against impact and shock. Cutting with
extreme force can significantly reduces the performance
capability of the tool and reduces the service life of the saw
blade. Sawing performance and cutting quality depend
essentially on the condition and the tooth count of the saw
blade. Therefore, use only sharp saw blades that are suited
for the material being cut.
Choice of blades: 24 teeth for general work, approx. 40 teeth
for finer cuts, more than 40 teeth for very fine cuts into
delicate surfaces, diamond for tile, cement board, etc.
Only use saw blades recommended.
MAINTENANCE
Remove the battery pack from the tool before carrying
out any adjustment, servicing or maintenance.
Keep tools sharp and clean for better and safer performance.
Follow instructions for lubricating and changing accessories.
Inspect tool cords periodically and if damaged, have repaired
by authorized service facility. Your power tool requires no
additional lubrication or maintenance. There are no user
serviceable parts in your power tool. Never use water or
chemical cleaners to clean your power tool. Wipe clean with
a dry cloth. Always store your power tool in a dry place. Keep
the motor ventilation slots clean. Keep all working controls
free of dust.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
Periodically clear dust and chips from guard and base to
ensure proper performance.
See Fig. C1, C2
See Fig. D1, D2
See Fig. E1, E2
See Fig. F
See Fig. G1, G2
See Fig. H
15
EN