Denon AVR-2803 Instrucciones De Operación página 14

ENGLISH
2
Switch to the Video In Assignment screen.
3
Select the component (Y, P /C and P
B B
q Input source selection
Select "NONE" for sources for which the component (Y, P
When the default, "Yes", is selected, the settings are reset to the factory defaults.
4
ENTER the setting.
The System Setup Menu reappears.
Setting the Dolby Digital Setup
Sets the down-mixing method when not using a center speaker or surround speakers.
OFF: The dynamic range is not compressed.
ON: The dynamic range is compressed automatically according to the combination of speakers being used.
1
At the System Setup Menu select "Dolby
Digital Setup" and press the ENTER button.
2
Select "ON" if you want to use the Compression, "OFF"
if you do not want to use it.
NOTE:
When not using a center speaker or surround speakers,
the sound is played from the front speakers. If the sound
should seem distorted because the input level exceeds the
allowable input for the front speakers, set "Compression"
to "ON".
3
Enter the setting.
The System Setup Menu reappears.
14
/C ) video input terminal to be assigned to the input source.
R R
w Component video terminal
selection
/C and P /C ) video input is not to be used.
B B R R
Setting the ZONE2 Control
[1] Setting the power amplifier assignment
Make this setting to switch the power amplifier for the surround back channel to ZONE2.
If ZONE2 is selected, the signal that selected at ZONE2 is output at "SURR. BACK/ZONE2 PREOUT"
terminals.
1
At the System Setup Menu select "Zone2
Control" and press the ENTER button.
2
The "Zone2 Control" screen appears.
Select "Power Amp Assignment" and press
the ENTER button.
3
Select "Surround Back" to use as the surround
back channel, "Zone2" to use as Zone 2 out.
4
Enter the setting.
At the "Zone2 Control" screen, select "Exit" and press the ENTER button.
The System Setup Menu reappears.
[2] Setting the Zone2 vol. level
Set the Zone 2 pre-out output level adjustment.
1
At the System Setup Menu select "Zone2
Control" and press the ENTER button.
2
The "Zone2 Control" screen appears.
Select "Zone2 Vol. Level" and press the
ENTER button.
When "Surround Back" is selected When "Zone2" is selected