Listening To The Radio - Denon AVR-2803 Instrucciones De Operación

12

LISTENING TO THE RADIO

• Check that the remote control unit is set to AMP mode (TAPE, CDR/MD or CD).
Auto tuning
1
Set the input function to "TUNER".
FUNCTION
(Main unit) (Remote control unit)
2
Watching the display, press
the BAND button to select
the desired band (AM or
FM).
(Remote control unit)
3
Press the MODE button to
set the auto tuning mode.
"Auto" appears on
display.
(Remote control unit)
4
Press the TUNING + (up) or –
(down) button.
Automatic searching begins,
then stops when a station is
tuned in.
(Remote control unit)
If tuning does not stop at the desired station, use to
the "Manual tuning" operation.
Manual tuning
1
Set the input function to "TUNER".
FUNCTION
(Main unit) (Remote control unit)
2
Watching the display, press
the BAND button to select
the desired band (AM or
FM).
(Remote control unit)
3
Press the MODE button to
set the manual tuning mode.
Check that the display's
"AUTO" indicator turns off.
(Remote control unit)
1
2
3
1 4
the
4
Press the TUNING + (up) or –
(down) button to tune in the
desired station.
The frequency
continuously
button is held in.
(Remote control unit)
NOTES:
• When in the auto tuning mode on the FM band, the
"STEREO" indicator lights on the display when a
stereo broadcast is tuned in. At open frequencies,
the noise is muted and the "TUNED" and
"STEREO" indicators turn off.
• When the manual tuning mode is set, FM stereo
broadcasts are received in monaural and the
"STEREO" indicator turns off.
Preset memory
1
Use the "Auto tuning" or "Manual tuning"
operation to tune in the station to be preset in
the memory.
2
Press the MEMORY button.
(Remote control unit)
3
Press the SHIFT button and
select the desired memory
block (A to E).
(Remote control unit)
4
Press the CHANNEL + (up)
or – (down) button to select
the desired preset channel (1
to 8).
(Remote control unit)
5
Press the MEMORY button
again to store the station in
the preset memory.
(Remote control unit)
To preset other channels, repeat steps 2 to 5.
A total of 40 broadcast stations can be preset
— 8 stations (channels 1 to 8) in each of blocks
A to E.
Checking the preset stations
• The preset (broadcast) stations can be checked on the on screen display (OSD).
1
Press the ON SCREEN/DISPLAY button repeatedly until the "Tuner Preset
Stations" screen appears on the on screen display.
changes
when the
(Remote control unit)
2, 5
1
ENGLISH
3
4
35