Denon AVR-2803 Instrucciones De Operación página 21

Punch Through
(1) Punch through button
Buttons used in the CD, CDR/MD, TAPE,
DVD/VDP, and VCR modes can be assigned to the
buttons shown on the diagram at the right which
are not normally used in the TV and DBS/CABLE
modes.
For example, when the CD mode is set to the
punch through mode in the TV mode, the CD
mode's PLAY, STOP, MANUAL SEARCH, AUTO
SEARCH, PAUSE and DISC SKIP buttons' signals
are sent in the TV mode.
(2) Making the punch through setting
1
Press the power ON/SOURCE button and the
OFF button at the same time.
• The LEARNED/TX indicator flashes.
2 Press the 1 (play) button.
• TV and DBS/CABLE mode buttons and
LEARNED/TX indicator flash.
3 Press the mode button of the equipment for
which Punch Through is to be set.
• The CD, CDR/MD, TAPE, DVD/VDP, and VCR
mode buttons and LEARNED/TX indicator will
flash.
4 Press the mode button of the equipment that is
to be punched through.
• The mode button that was set will light.
Resetting
(1) Resetting "learned" buttons
1 1
1
4
3
2
(1)
2
3
4
Press the USE/LEARN button with the tip of a
pen, etc., to set the learn mode.
• The mode selector buttons and LEARNED/TX
indicator flash.
Flashes
Press the mode button of the equipment that is
to be reset.
• Mode button and LEARNED/TX indicator
flash.
Hold for 4 seconds or longer the mode button of
the equipment that is to be reset and the
ON/SOURCE button.
• The mode button and the LEARNED/TX
indicator will again flash, and the learned
remote control signal of the selected
equipment will be deleted.
Press the USE/LEARN button.
ENGLISH
3
2, 3
1, 4
21