Denon AVR-2803 Instrucciones De Operación página 16

ENGLISH
Setting the Trigger Out Setup
• Sets the Trigger Out output for the different input sources.
1
At the System Setup Menu select "Trigger Out Setup".
2
Switch to the Trigger Out Setup screen.
3
Select the input source and select "ON" or "OFF".
4
Enter the setting.
The System Setup Menu reappears.
Auto tuner preset
Use this to automatically search for FM broadcasts and store up to 40 stations at preset channels A1 to 8, B1 to
8, C1 to 8, D1 to 8 and E1 to 8.
NOTE:
• If an FM station cannot be preset automatically due to poor reception, use the "Manual tuning" operation to
tune in the station, then preset it using the manual "Preset memory" operation.
1
At the System Setup Menu select "Auto Tuner Presets".
2
Press the ENTER button.
The "Auto Preset Memory" screen appears.
16
3
Use the CURSOR button to select "Yes".
"Search" flashes on the screen and searching begins.
"Completed" appears once searching is completed.
The display automatically switches to screen.
Protecting the setting
• The system setup settings can be locked so that they cannot be changed easily.
1
At the System Setup Menu select "Setup Lock".
2
Switch to the Setup Lock screen.
3
Select "ON", to lock the system setup settings.
4
Press the ENTER button to finalize the setting and exit the system setup mode.
When the setup lock function is activated, the settings listed below cannot be changed,
and "Setup Locked" is displayed when related buttons are operated.
• System setup settings
• Surround parameter settings
• Tone control settings
• Channel level settings (including test tones)
To unlock, press the System Setup button again and display the Setup Lock screen, then
select "OFF" and press "ENTER".
System setup is complete. Once these settings are made, there is no need to change them unless
different AV components are connected or the speakers are repositioned.