Demounting - Beissbarth MS 75 Manual Original

�.1.�

Demounting

Warning–handinjurydanger!
Crush injuries risk during locking plate rotati-
on.
¶
Do not insert the fingers between the tire
and the rim.
Warning-damagerisk!
When using the hydraulic system control unit
for extraction, the rim and the bead breaking
rollers can both be damaged.
¶
The mounting tool has to be extracted in
the same way it has been inserted in the
edge/shoulder of the rim.
Demountingoftubelessandsupersingletires
1. Lock manually the operating arm on the trolley with
the bead breaking disk facing the bead.
2. Use the control lever to position the bead breaking
disk in correspondence with the internal edge of the
rim.
3. Use the control lever to press, with the bead brea-
king disk, the tire bead towards the rim drop centre
and use the pedal to rotate without interruptions the
locking flange until completing an entire circumfe-
rence of the rim.
i
Use mounting paste to help detach the tire from the
rim.
4. Press the pedal to release the working arm and use
the manipulator to move the trolley to the side oppo-
site the chuck bearing arm.
5. Remove the pin, turn the tool 180° and re-insert the
pin.
Beissbarth GmbH
All manuals and user guides at all-guides.com
6. With the working arm upright, move the trolley to-
7. Use the control lever to press with the bead breaking
i
i
Operatinginstructions|����|2�
wards the chuck bearing arm and past the tyre, and
fasten the working arm manually onto the trolley.
disk the tire bead towards the drop centre of the rim
and use the pedal to rotate without interruptions the
locking flange until complete ejection of the tire from
the rim.
For demounting of particularly hard supersingle
textile-reinforced tires or tubeless tires with high
edge balcony design rims refer to the instructions for
demounting of agricultural wheels
To make demounting operations easier it is possible
to use the tubeless tire roller (1).
����|2� |2� en
1
|
1 695 301 979 2011-07-16