Uline H-2241 Manual De Instrucciones página 2

MOUNTING THE DISPENSER
For best operation, mount the dispenser 7 to 9 feet
above the floor.
1. Open dispenser by pushing key into lock on side of
unit. Twist key to vertical position to unlock, then pull
down on face of dispenser to open.
2. Place the dispenser in the desired location to be
mounted. Make a mark on the wall surface through
the two mounting holes.
3. Drill the holes at the marks and insert the anchors.
4. Place the unit on the wall and affix the screws.
5. Ensure the dispenser is mounted securely.
PROGRAMMING THE DISPENSER
1. Insert 2 "D" alkaline batteries in the battery
compartment, leaving black ribbon behind
batteries for easy removal.
2. Turn the unit ON. ON/OFF switch is located on the
side of the dispenser.
NOTE: Do not insert aerosol can in the
dispenser yet.
3. Set the clock by pressing the MIN and HRS buttons.
Clock is set in military time.
4. Set day by pressing the DAY button repeatedly until
correct day is illuminated.
5. Dispenser is set and activated.
TO SET ACTIVE DAYS
NOTE: Factory default is all days active.
1. Press the SERVICE button four times until "Off Days" is
illuminated.
2. Press the DAY button to illuminate and deactivate
each day of the week.
a. Press the DAY button once to deactivate
unwanted days. Deactivated days will be
displayed.
b. Press the DAY button twice to skip the active
days.
3. There will be a slight pause between each day as
the dispenser cycles through all the days of the
week.
4. Once there is no activation on the DAY button for 5
seconds, the dispenser will save and go to the date
and time screen.
PAGE 2 OF 9
MOUNTING AND PROGRAMMING
5. Active days can have specific times in which the
dispenser turns on and off.
a. Press the SERVICE button once to ON to set the
time to start each active day. Change time by
using the MIN and HRS buttons.
b. Press the SERVICE button two times to OFF to set
the time to end each active day. Change time
by using the MIN and HRS buttons.
c. Once there is no activation on the DAY button for
5 seconds, the dispenser will save and go to the
date and time screen.
TO CHANGE THE SPRAY INTERVALS
NOTE: The default is every 15 minutes 24 hours
a day.
1. Press the SERVICE button three times to INT to set
interval time each active day. Change interval by
using the MIN button.
2. Once there is no activation on the DAY button for 5
seconds, the dispenser will save and go to the date
and time screen.
3. The dispenser is fully programmed.
4. Test spray by putting a can into the dispenser and
press the circle button underneath the ON/OFF
button on the side of the dispenser. Do not stand
directly in front of the dispenser.
BATTERY LIFE
1. Hold down the SERVICE button for 3 seconds to view
the battery life.
2. When battery life is low, a battery icon will appear
on the main screen.
3. The dispenser will hold settings for 60 seconds while
changing the batteries. Otherwise all settings will
revert back to factory settings.
CAN LIFE
1. Hold down the SERVICE button for 3 seconds
and press the SERVICE button again to view the
remaining days left in the aerosol can.
2. Each time the can is replaced, press the RESET
button.
0721 IH-2241