Step 1- Rear Axle And Brake Assembly; Step 2 - Rear Wheel Assembly - GAGGLE JAMBOREE 6 Manual Del Usuario

STEP 1 - Rear Axle and Brake Assembly
1.
Lay folded Stroller Frame Assembly (A) on
clean floor with handle tube (1) on top and front
footrests (2) contacting floor (Fig. 1).
2.
Assemble Rear Axle Tube Assembly (C)
to stroller (Fig. 2).
- Position Rear Axle Tube Assembly (C) with brake
tube (3) up and open end of rear axle
assemblies toward rear legs.
- Slide rear axle tube assembly (C) onto the
lower ends of rear legs (4) until contacting
spring pins. Press spring pins and slide
rear axle assembly (C) onto rear leg (4) until
spring pins snap into holes in rear axle
tube assembly (C) .
- Pull on Rear Axle Tube Assembly (C) to check
that it is secured onto rear legs.
1.
Align hole in Rear Wheel axle rod (B) with holes in
Rear Axle Tube Assembly (C). Slide rear wheel with
axle B into Rear Axle Tube Assembly (C) until hole in
rear axle rod aligns with hole in rear axle tube (Fig. 1).
2.
Insert M6 x 34 mm Screw (H) through Rear Axle Tube
Assembly (C) and rear axle rod until screw comes out bottom of
Rear Axle Tube Assembly (C) (Fig. 2).
NOTE: If end of screw does not slide into hole, check
alignment of hole in axle. If hole in axle is not
aligned, remove rear wheel and start over.
3.
Insert M6 Nut (I) into 6-sided recess on bottom of
rear axle tube and using phillips screwdriver, secure
Screw (H) by turning into nut until tight (Fig. 3).
Repeat steps 2 thru 3 for opposite rear wheel.

STEP 2 - Rear Wheel Assembly

2
3
C
5
1
2
Style May Vary
4
B
H
H
I
Fig. 1
Fig. 2
Fig. 1
C
Fig. 2
C
Fig. 3