Step 3 - Front Wheel Assembly - GAGGLE JAMBOREE 6 Manual Del Usuario

1.
Unfold stroller (see "Operation and Use" section).
2.
Tip stroller back on rear wheels until handle contacts
floor (Fig. 1).
3.
Gather all parts required for assembly. Locate
M6 x 25 Shoulder Screw (K), Lock Washer (L),
and Flat Washer (M) in parts bag. Locate Front
Wheel Assembly (D).
4.
Remove protective packaging material from Front
Wheel Post (Fig. 2).
NOTE: Hold bearing (Y) on front wheel post (X) while
removing protective packaging materials
and parts bag.
5.
While holding bearing on front wheel post, position
Front Wheel Assembly (D) so bearing race (Z) is
facing front wheel post (X) and bearing (Y) inside Front
Wheel Assembly is on opposite side, slide Front Wheel
Assembly onto front wheel post and bearing
(Fig. 3).
6.
Slide Lock Washer (L) and Flat Washer
(M) onto M6 x 25 mm Shoulder Screw (K)
and then insert screw into bottom of front
wheel post and tighten securely (Fig. 4).
Repeat steps 2 thru 6 to assemble
front wheel on other side of stroller.

STEP 3 - Front Wheel Assembly

L
K
6
Y
X
Z
M
Fig. 1
Fig. 2
Fig. 3
Y
Fig. 4