General Setting - Youin BK3000 Manual De Usuario

8. LCD Display
· Error Code Indication
When E-Bike electronic control system fails, the
display will show error code automatically. For the
definition of the detailed error code, please refer to
attached List 1.
Error code indication
When the error code is display, please troubleshoot the fault in time.
After the fault occurs, the E-Bike will not be able to drive normally. If you can not
solve it, please contact your local dealer for help.

8.4 General Setting

Long press the ON/OFF button to turn on the display. In the power-on state, when
the vehicle is stationary, press and hold the ON/OFF button and DOWN button at the
same time for more than 1 second, the display will enter general setting state.
· All various settings need to be performed when vehicle is stationary.
· Wheel size setting
DIA indicates wheel size, the possible settings are:
12, 14, 16, 18, 20, 22, 24, 26, 700C/27.5, 28, 29. Short
press UP or DOWN button to select the wheel size
corresponding to the vehicle to ensure the accuracy
of speed and mileage of display. Short press Switch
button to enter speed limit setting interface, and
then press UP or DOWN to adjust wheel size.
Wheel size setting interface
· Boost Speed Setting
PSH indicates boost speed, the selectable range of
the boost speed setting value is between 3km/h
and 6km/h, short press UP or DOWN button to set
the Plus/Minus. The default maximum riding speed
of display is uploaded by the controller. Press UP or
DOWN button to increase or decrease the speed
limit value until the required value displayed. Long
press ON/OFF button for more than 1 second to
confirm and exit setting state.
Boost speed display
23
ENGLISH